Table of Contents
Advertisement
B.2
LAN Bypass
B.2.1
Introduction
The FWS-2365 supports LAN Bypass to allow uninterrupted network traffic even if a
single in-line appliance is shut down or hangs.
B.2.1
LAN Bypass Configuration
Table1: LAN Kit ID Select
LAN_ID2
LAN_ID1
0
0
Table2: LAN Bypass relative register table
Function
LAN_ID3
LAN_ID2
LAN_ID1
LAN_ID0
PWR_ON
PWR_OFF
WDT_EN
ACT_EN
Appendix B – Hardware and LAN Bypass Programming
LAN_ID0
0
0
0
1
Used to select which LAN Kit will be configured (see
Table 1 of this section). These parameters should be
set before ACT_EN
Use for configuring LAN Bypass function behavior
for selected LAN kit, when system power is on.
1: Bypass
0: Pass Through
Use for configuring LAN Bypass function behavior
for selected LAN kit, when system power is off.
1: Bypass
0: Pass Through
Use for configuring WDT function behavior for
selected LAN kit, when WDT is triggered.
0: Normal WDT reset (Default)
1: Force Bypass
Use for activating programming of LAN kit. It is
edge triggering (falling edge 1 to 0) and should be
set to high(1) as its normal state.
LAN kit selected
LAN Kit 1 Selected
LAN Kit 2 Selected
Description
89
Advertisement
Table of Contents
