Table of Contents
Advertisement
Chapter 2 Preparations
Removal / Replacement
1.10.6
To remove DIMM, reverse the installation procedure.
Be sure to install dummy cover to the slots from where DIMMs are removed.
Take the steps below after replacing or removing DIMMs.
1.
Confirm that no error messages are displayed on POST. If any error message is displayed, refer to
Chapter 3 (1. Post Error Message) in "Maintenance Guide".
2.
Run BIOS Setup Utility, select Memory Configuration from the Advanced menu, and then specify Yes
for Memory Retest. After that, select Save Changes and Exit to reboot.
3.
Set the size of Paging File to the recommended value (Total memory size x 1.5) or more.
If using a Windows OS, refer to Chapter 1 (7.1 Specifying Memory Dump Settings (Debug Information))
in "Installation Guide (Windows)".
For other OS, follow the manual of the OS.
64
Important
Failing to install dummy cover to vacant slot may cause malfunction of the
server due to insufficient cooling effect.
Note
• When removing a defective DIMM, check error messages displayed at POST or
NEC ESMPRO and check the DIMM socket where the defective DIMM is
installed.
• At least one DIMM needs to be installed for the server to operate.
Express5800/R120d-1M User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
