Hitachi CG40EK Owner's Manual page 10

Fig. 1-4 Fig. 1-5 Fig. 1-6
Throttle wire / stop cord
Remove air cleaner cover. (Fig. 1-4)
Connect stop cords. (Fig. 1-5)
Connect throttle wire end to carburetor. (Fig.1-5)
Cover throttle wire and stop cords together with
protective tube provided up to air cleaner cover.
(Fig. 1-6)
Installation of blade guard (Fig. 1-8)
NOTE!
The guard bracket may come already mounted
to the gear case on some models.
Install the blade guard on drive shaft tube
against angle transmission. Tighten the guard
bracket firmly so that the blade guard does not
swing or move down during operation.
CAUTION!
Some blade guards are equipped with sharp
line limiters. Be careful with handling it.
GB-8