NEC NAR01 Instruction Manual page 25

Important safety information regarding radio frequency
(RF) exposure and use when worn
The product "NAR01(Mobile Router)"is declared to conform with the essential
requirements of the Federal Communications Commission of the U.S.
Government.
This wireless portable device complies with the FCC requirements for
exposure to radio waves.
Your wireless portable device is a radio transceiver and receiver. It is
designed not to exceed the SAR*(Specific Absorption Rate) limits** for
exposure to radiofrequency (RF) energy by the FCC Directives.
The Max. SAR* value is 0.95W/kg (1 g) when it is worn on the body. To
comply with the RF Exposure limits.
For body worn operation, this device has been tested and meets the FCC RF
exposure guidelines. During communication, please use an accessory
designated for this product and which positions the device a minimum of
0.1cm from the body.
The use of accessories that do not satisfy these requirements may not
comply with FCC RF exposure requirements, and should be avoided.
* The exposure standard for wireless portable devices employs a unit of measurement
known as the Specific Absorption Rate, or SAR.
** The SAR limit recommended by the FCC is 1.6W/kg averaged over 1g of tissue.
*** Tests for SAR have been conducted using standard operating positions with the
transmitting at its highest certified power level in all tested frequency bands. Although
the SAR is determined at the highest certified power level, the actual SAR level of the
wireless portable device while operating can be well below the maximum value. This
is because the wireless portable device is designed to operate at multiple power
levels so as to use only the power required to reach the network. In general, the
closer you are to a base station antenna, the lower the power output.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 10mm must be
maintained between the user's body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device
should not contain any metallic components.
Body-worn accessories that do not meet these requirements may not comply
with RF exposure requirements and should be avoided.