Appliance And Building-In Dimensions; Preparing The Worktop - Miele CS 1418 Operating And Installation Instructions

en-GB
Appliance and building-in
dimensions
1 5
2 7 2
5 0
a Spring clamps
b Casing depth

Preparing the worktop

^ Make the worktop cut-out for one or
several appliances following the
dimensions applicable.
^ Seal the cut surfaces with a suitable
heat-resistant sealant to avoid
swelling caused by moisture.
The materials used must be
heat-resistant.
If, during installation, you find that the
seals on the corners of the frame are
not flush with the worktop surface,
the corner radius (ß R4) can be
carefully scribed to fit.
10
2 8 8
+
- 1
5 0 0 +
- 1
5 2 0
a
ß
R 4
3 2
b
4 0
0