AEG LTN7C562C User Manual page 24

24 www.aeg.com
2. Press button Start/Pauza.
The appliance starts the countdown of
the delay start.
When the countdown is completed, the
programme starts automatically.
Before you press button
Start/Pauza to start the
appliance, you can cancel or
change the set of the delay
start.
13.9 Cancelling the delay
start
To cancel the delay start:
1. Press button Start/Pauza to set the
appliance to pause.
The related indicator flashes.
2. Press button Odložený start
repeatedly until the display shows .
3. Press button Start/Pauza again to
start the programme immediately.
13.10 Interrupting a
programme and changing a
option
You can change only some options
before they operate.
1. Press button Start/Pauza.
The related indicator flashes.
2. Change the option set.
3. Press the button Start/Pauza again.
The programme continues.
13.11 Cancelling a running
programme
1. Press button Zap./Vyp. to cancel the
programme and to deactivate the
appliance.
2. Press button Zap./Vyp. again to
activate the appliance.
Now, you can set a new washing
programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
13.12 The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Start/Pauza button,
the maximum declared load indicator
goes off, the indicator
ProSense starts the laundry load
detection:
1. The appliance detects the load in the
first 30 seconds: the indicator
the time dots flash, the drum rotates
shortly.
2. At the end of the load detection, the
indicator goes off and the time
dots stop flashing. The programme
duration will be adjusted accordingly
and could increase or decrease. After
further 30 seconds, the water filling
starts.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pauza button to start the
programme again. The ProSense phase
can be repeated up to three times (see
point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
flashes, the
and
is