Huawei WebConnect Jet UMG1691 Quick Start

UMG1691 webConnect
Quick Start
Thank you for choosing the Mobile Broadband
USB Stick. With your USB Stick, you can access
a wireless network at high speed.
Note:
This manual describes the appearance of the USB Stick, as well as the
procedures for preparation, installation, and removal. For operation details
about the management program, see the online help included in the
management program.
Getting to Know Your USB Stick
The following figure shows the appearance of the USB Stick. It is provided
only for your reference. The actual product may be different.
1
2
Rotatable USB Connector
It connects the USB Stick to a PC.
Indicator
It indicates the status of the USB Stick.
Green, blinking twice every 3s: The USB Stick is powered on.
Green, blinking once every 3s: The USB Stick is registering with a 2G
network.
Blue, blinking once every 3s: The USB Stick is registering with a
3G/3G+ network.
Green, solid: The USB Stick is connected to a 2G network.
Blue, solid: The USB Stick is connected to a 3G network.
Cyan, solid: The USB Stick is connected to a 3G+ network.
Off: The USB Stick is removed.
RF Output Power Port
It connects an RF cable to the USB Stick for RF tests.
MicroSD Card Slot
It holds a microSD card.
SIM/USIM Card Slot
It holds a Subscriber Identity Module (SIM) /Universal Subscriber Identity
Module (USIM) card.
Getting Your USB Stick Ready
1. Slide the back cover to remove it from the USB Stick.
2. Insert the SIM/USIM card and the microSD card into the
corresponding card slots, as shown in the following figure.
3. Replace the back cover and slide it into place.
Note:
The microSD card is an optional accessory. If it is not provided in the
package, you can buy one yourself.
Ensure that the beveled edge of the SIM/USIM card is properly aligned
with that of the SIM/USIM card slot / holder and the microSD card is
inserted according to the direction as labeled on the microSD card slot.
Jet
3
4
5