Table of Contents
Advertisement
Installation
Basic installation
Before installing, make sure that the ignition-
switch is set to OFF and remove the terminal
of the car battery to avoid short-circuiting.
1. Remove the existing receiver unit.
2. Make the necessary connections.
3. Install the installation sleeve.
4. Install the unit into the installation sleeve.
Bend the claws
according to the
thickness of the
dashboard.
Removing the existing receiver
unit
If there is already an installation sleeve for the
receiver unit in the dashboard, it must be
removed.
1. Remove the rear support from the unit.
2. Remove the control panel and trim ring
from the unit.
3. Insert the lever A into the hole on one
side of the unit. Perform the same
operation on the other side and pull the
unit out from the mounting sleeve.
A
A
ISO-DIN Installation
1. Slide the unit into the ISO-DIN frame.
2. Install screws removed from the old unit.
3. Slide the unit and frame into the dash
opening.
4. Install the dash panel or adapter plate.
5. Install the trim ring to the unit.
5
Detaching the control panel
You can detach the control panel when leav-
ing the car.
When detaching or attaching the control
panel, be careful not to damage the connector
on the back of the control panel and on the
panel holder.
1. Press the "
" button to unlock the control
panel.
2. Pull the control panel out of the unit.
3. Put the detached control panel into the
provided case.
Attaching the control panel
1. Insert the left side of control panel into the
groove on the panel holder.
2. Press the right side of control panel to fix it
to the panel holder.
15
1
2
3
4
Advertisement
Table of Contents
