Hitachi W 6VM Handling Instructions Manual page 8

English
4. Inspecting the carbon brushes
For your continued safety and electrical shock
protection, carbon brush inspection and replacem ent
on this tool should ONLY be perform ed by a Hitachi
Authorized Service Center.
5. Service and repairs
All quality pow er tools w ill eventually require
servicing or replacem ent of parts because of w ear
from norm al use. To assure that only authorized
replacem ent parts w ill be used, all service and repairs
m ust be perform ed by a Hitachi Authorized Service
Center, ONLY.
CAUTION
Be sure to follow the above assem bly procedures
exactly. Should be internal w iring contact the
arm ature or becom e pinched betw een the handle
cover and housing, a serious risk of electric shock
to the operator w ould be created.
Do not tam per w ith parts other than those necessary
to effect carbon brush replacem ent.
6. Service parts list
A: Item No.
B: Code No.
C: No. Used
D: Rem arks
CAUTION
Repair, m odification and inspection of Hitachi Pow er
Tools m ust be carried out by a Hitachi Authorized
Service Center.
This Parts List w ill be helpful if presented w ith the
tool to the Hitachi Authorized Service Center w hen
requesting repair or other m aintenance.
In the operation and m aintenance of pow er tools, the
safety regulations and standards prescribed in each
country m ust be observed.
M ODIFICATION
Hitachi Pow er Tools are constantly being im proved
and m odified to incorporate the latest technological
advancem ents.
Accordingly, som e parts (i.e. code num bers and/or
design) m ay be changed w ithout prior notice.
NOTE:
Due to HITACHI's continuing program of research and
developm ent, the specifications herein are subject to
change w ithout prior notice.
Information concerning airborne noise and vibration
The m easured values w ere determ ined according to
EN60745 and declared in accordance w ith ISO 4871.
The typical A-w eighted sound pressure level: 85 dB (A).
Uncertainty KpA: 3 dB (A).
Wear ear protection.
The typical w eighted root m ean square acceleration value
does not exceed 2.5 m /s
6
2 .