Step 1: Provide Cabinet Support And Anti-Tip Bracket; Step 2: Install Warming Drawer - GE ZKD910 Installation Instructions Manual

Provide
Cabinet
Support
Important:
check to be sure that any oven supports above the cutout do not
obstruct the 23-1/2" required depth of the warming drawer cutout.
• A 2" min. clearance between oven and
Step 1
Install
Anti-Tip
Brackets
• Slide left corner of the drawer into the
Step 2
Install
• Push power cord into the hole leading to the
Warming
Drawer
• Push the drawer back until the front flange is
23-1/2"
22"
27"
When installed below a single or double oven,
warming drawer cutouts are required.
Additional clearance may be required if 2 x 4
blocks are used to support runners or solid
floor of the oven above.
WARNING
ANTI-TIP PRECAUTIONS
An anti-tip brace must be installed to
prevent the drawer from tipping for ward
when opened and loaded.
Failure to do so could result in personal
injury.
opening.
outlet location. Thread the cord through as
drawer is being pushed back into the open-
ing. Check to be sure power cord does not
get trapped under the drawer.
– If the outlet is installed inside the opening,
plug the cord into the outlet. Coil power
cord and secure to warming drawer side
with power cord clip.
flush to the cabinet front.
Installation
2"x 4" or
Equivalent Runners
23-1/2"
• The warmer drawer may be supported by
either a solid bottom, 2 x 4 or 2 x 2 run-
ners.
• The support must be level and rigidly
mounted, flush with the bottom edge of the
cutout.
– There is no way to level the drawer once it
has been installed. Be sure supports are
level.
• The entire weight of the drawer is supported
by the runners or solid floor and must be
capable of supporting 150 lbs.
• Open the drawer fully.
• Drill pilot holes through the holes in the
overlaping frame, one on each corner.
• Drive wood screws provided into each
corner.
Warming Drawer
2"x 4" or
Equivalent Runners
25"
30"
9"
2x4 or 2x2
Runners or Solid
Bottom
Install
2x4 or 2x2
Anti-Tip Block
Against Rear
Cabinet Wall
9" From Floor
to Bottom
of Block
7