Connect To Your Computer - Epson Stylus Photo RX620 Start Here Manual

6
Install Software and

Connect to Your Computer

The software works with Windows
OS 9.2.x and 10.2.x to 10.3.x. Follow the steps below (for Windows), or the
steps in the next column (for Macintosh).
W i n d o w s
1
Make sure the RX620 is not
connected to your computer,
then turn on your computer.
Note: If you see several New
Hardware Wizard screens, click
Cancel for each of these screens and
d i s c o n n e c t your RX620. You can't
install your software that way.
2
Insert your RX620 software CD-ROM
in your CD-ROM or DVD drive.
Note: If you're using Windows XP and you see a message asking what
to do with your CD, click Cancel.
3
When you see this screen,
then click Install.
Note: If you don't see this screen,
do the following:
Windows XP: click Start >
My Computer. Then double-click
the Epson CD-ROM icon.
Windows 98/Me/2000: double-click
Then double-click the Epson CD-ROM icon.
4
Read the license agreement, then click Agree. Several messages
display on your screen.
5
When you see this screen, plug the flat
end of the USB cable into any available
USB port on your computer.
6
Click Next to continue the installation.
Note: It will take several minutes to install the software. Click Next or
Finish, as prompted. Don't cancel the installation.
7
When the installation is complete, print a test page, if desired. Then
click Next to install optional software.
8
Follow the instructions on the screen to install the software. When done,
click Exit.
9
When you see the Product Registration screen, register your RX620 as
instructed, then remove the CD-ROM and restart your computer.
Now you're ready to copy, scan, and print. See the Quick Guide or your
on-screen Reference Guide for instructions.
98SE, Me, 2000, and XP, and Macintosh
®
My Computer.
®
continue