Maintenance; Troubleshooting Guide - Frigidaire EFWC498 Instruction Manual

Remove power plugs or disconnect from the mains before performing any maintenance
or servicing the product.
Never us detergent or chemicals harmful to health to clean the water tank.
Do not directly spray water on the surface of the product.Wipe the front and back of
the product with water-soaked soft cloth.
If dust of other foreign substance has accumulated on the condenser, wipe off with
water soaked soft cloth.
After cleaning the product, completely dry it. Fill the water to the tanks until waters
comes out of the hot water tap, then connect the electric power plug. If the surface
of the electric heater in the hot water tank is deposited by water deposition, heating
capacity will decrease. Fill hot water tank with aqueous solution of 2% iatric acid
and keep for about two hours then cleaning. If the problems can not be solved
contact your dealer or the service centre of our company.
If the supply cord on this device is damaged. It must be replace with a special cord
switch is obtainable at the service centre of our company.
Problem
Water cooler does not operate
Water cooler is not cold enough
Water cooler hot water is not hot
enough
Compressor turns on and off
frequently
Vibration

MAINTENANCE

TROUBLESHOOTING GUIDE

Possible cause
Not plugged in
The circuit breaker tripped or blown fuse.
Check to be sure the cold switch on the back is
on.
The water cooler does not have the correct
clearance.
Check to be sure the hot switch on the back is
on.
The room temperature is hotter than normal.
The water cooler does not have the correct
clearance.
Check to assure that the water cooler is level