Replacing a Toner Cartridge installation window When the printer runs out of toner, the control panel display indicates the color of the toner cartridge that needs to be replaced. Make sure you have the correct replacement cartridge, as shown in the table, and then follow these steps.
Page 4
Avoid exposing the unit to room light any longer than necessary. Also, don’t touch or scratch the surface of the drum. Turn off the printer and open the front cover. Turn the large lever counterclockwise 90 degrees. Turn the small lever on the photoconductor unit to the right.
Page 5
Waste Toner Collector (Continued) waste toner collector Position the unit over the guide rails inside the printer. Then carefully slide it all the way in. Turn the small lever on the unit to the left. Turn the large lever clockwise 90 degrees.
Hold the roll handle and insert it into the fuser unit, matching the green marks on the roll and unit. positioning marks Push the roll down firmly until it clicks into place. Slide the fuser unit back into the printer. S052002 handle...
Clearing Paper Jams Clearing Paper Jams paper cassette When a paper jam occurs, the printer stops and displays a message on the control panel. The table below lists the error messages and tells you where to check for jammed paper: Message...
Page 8
If paper is jammed inside the printer, pull out the multipurpose tray until it stops. Raise the paper path cover. Turn the knob clockwise. The jammed paper should come out.
Clearing Paper Jams (Continued) Clearing Paper Jams (Continued) fuser unit face-up output tray Clearing the fuser unit If you see paper jammed in the path to the face-up output tray, don’t try to pull it out of the tray. You’ll need to clear it from the fuser unit instead: Pull the fuser unit out gently until it stops.
Exiting Paper Jam these steps to clear paper from the output path cover: Open the output path cover on the left side of the printer. Carefully lift or pull the jammed paper out of the printer. Close the output path cover.
Reset The printer’s current interface has been reset and the buffer is cleared. Reset All All printer settings have been reset to the user default configuration, the last settings that were saved. Reset to Save You should reset the printer to save the current settings.
Page 12
Replace the indicated toner cartridge (see page 1). Write down the error number and turn off the printer. Wait at least 10 seconds and then turn it back on. If this error still appears, turn off the printer, unplug the power cord, and contact...