Test The Printer - Epson Stylus 1520 Quick Setup Manual

5. Slide out the rear paper support guide until
it stops.
6. Fan a stack of paper and then even the edges.
7. Load the stack with the printable side face
down. (The printable side is usually whiter
and brighter.) Slide the stack all the way into
the feeder, with one edge of the stack
touching the right edge guide.
8. Slide the left edge guide against the left side
of the paper. Then slide the rear paper
support against the end of the paper.
9. Lower the output tray.
6

Test the Printer

1. Turn off the printer and wait until the
2. While holding down the
button.
Load/Eject
The first page prints on the first and last lines to measure the page length. The next sheet
prints a multicolor nozzle check pattern and character samples at 360 dpi (dots per inch).
3. After the second page prints, press the
button to eject any paper remaining in the sheet feeder.
Load/Eject
Caution:
Never turn off the printer while it's printing test pages. Always press the
Pause button and eject any loaded paper first.
Operate
button, turn the printer on. Then release the
Load/Eject
button to stop the test. Then press the
Pause
7
light turns off.
Quick Setup