MB2147 – Installation Guide
Chapter 2 Setting up the Emulation System
2.1.13 Power connection
Connect a power supply to the Emulator first, then switch on the emulator. This prevents
damages in the Adapter Board, in the Evaluation Chip and in the Emulator itself.
The power LED should be lighting green and in the LC display the following text should
occur: "NO CONNECT [Enter]: MENU"
After this connect a power supply to the target system, i. e. the Starter Kit Board.
2.1.14 Power down
Contrariwise to the power-on connection the power on the target system has to switched off
first during power-down.
The emulator has to be switched off at last.
MCU-AN-390070-E-V29
- 16 -
© Fujitsu Microelectronics Europe GmbH