Loading Roll Paper - Epson Stylus Photo 2000P Product Information

Loading Roll Paper

When loading roll paper, be sure to follow the instructions in
this section. Also, make sure
Paper Source in the printer driver.
1. Before loading the roll,
make sure the edge is cut
cleanly—at a 90-degree
angle in each corner—to
ensure proper loading. If
necessary, trim the edge
using a straight-edge tool.
2. To make loading easier, roll the first several inches of the
paper backward to uncurl it. Use the plastic sheet included
with your printer to prevent your hands from marring the
printable surface. (Or you can use a folded sheet of paper.)
3. Remove the printer's paper support and install the roll
paper holder in the same mounting slots.
4. Insert the roll paper onto the spindle, making sure it's
oriented as shown here. Then place the spindle with the roll
paper onto the holder.
is selected as your
Roll Paper
5. Load the end of the paper into the printer as far as it will go,
then slide the left edge guide against the paper.
6. Gently hold the paper in place as you press and release the
E load/eject button to feed the paper into the printer. Avoid
handling the paper excessively, to prevent contamination
with dirt or grease.
(If the paper doesn't feed properly, lift the paper out and
then reload it. If the paper doesn't come out easily, hold
down the E load/eject button for three seconds. Then turn
the printer off, remove the paper, and turn the printer back
on to reset it. When reloading, make sure the end is cut
straight and not curled or damaged. If necessary, re-trim the
paper as shown in step 1.)
7. Make sure the output tray is open but the extensions are
closed, and leave ample room at the front of the printer for
your paper to eject smoothly.
6/00
EPSON Stylus Photo 2000P
EPSON Stylus Photo 2000P
- 7