Projector At A Glance; Using The Control Panel; Using The Remote Control; Using Your Projector - Epson PowerLite 8000i Quick Setup

Projector at a Glance

Using the Control Panel

Help
Displays the projector's
online help
Power button
Turns projector
on and off
Computer
Switches connected
computer sources
sequentially
A/V Mute
Turns off the audio-video
Resize
Provides display
options for multiple
resolutions
Video
Switches to the Adjusts the volume
video input source

Using the Remote Control

Freeze
Freezes the computer
or video image
A/V Mute
Turns off the
audio-video
E-Zoom
Enlarges or reduces
the image size
Illumination
Illuminates all buttons
on the remote control
Esc
Ends the
current function;
returns to previous
menu/screen;
acts as a right
mouse-click when the
image source is
Computer
Menu
Displays or hides the menu
Esc
Ends the current function;
returns to previous
screen/menu
Enter button
Registers a menu selection
Tracking +,Tracking -
(right and left arrows)
Adjusts projector to
match the computer signal
Sync +, Sync -
(up and down arrows)
Adjusts projector to
match the computer signal
- Volume + - Keystone +
Adjusts a trapezoid
when used in image to a normal rectangle
conjunction with
the Shift button
Power
Starts or stops
the projector
RC on/off
Turns the
remote control
on or off
Menu
Comp1
Effects buttons
(1-5)
S-Video
Display pre-
Auto
programmed
P in P
special effects
- Volume +
Enter (Pointer)
Navigates menu system;
acts as a mouse pointer;
acts as a left mouse-click
when the image source
is Computer
Control panel
Optical keystone
adjustment knob
Foot adjust levers

Using Your Projector

1. Plug in the projector. The power light on the projector's control panel
turns orange. (The projector is not on yet.)
2. Remove the lens cap.
3. Press the Power button on the control panel or remote control
once to turn on. The power light flashes green as the projector
warms up. Then turn on your computer.
Warning: Never look into the lens when the lamp is on.
4. You can set the display to appear on both the computer's screen and
the projector. Check your computer manual for instructions.
Help
5. To adjust the projected image size, rotate the zoom (outside) ring
BNC
on the projector. For larger adjustments, you may need to
Video
reposition the projector closer to or farther from the screen.
Resize
6. To focus the image, rotate the focus (inside) ring.
Preset
7. If the image is too high or low, lift up the foot adjust levers to raise
or lower the adjustable feet. Release the levers to lock the feet
in place.
8. When you want to stop projecting images, press the Power button
again.The projection light flashes orange as the projector cools down.
When you are done, make sure the projection light has stopped
flashing and then unplug the power cord.
Caution: Never unplug the power cord when the power light
is green; this may damage the lamp.
For instructions on setting up your projector with a desktop computer or for information
on using the ELP Link IV software to control the projector, see your User's Guide.
EPSON and PowerLite are registered trademarks of SEIKO EPSON CORPORATION.
Copyright © 1999 by Epson America, Inc.
EPSON PowerLite 8000i
EPSON PowerLite 9000i
Focus ring
Zoom ring
Infrared
receiver
CPD 9113