Advertisement
Quick Links
Before replacing the radio, be sure to disconnect power to the pedestal.
A
Old Radio Removal
3
Disconnect
power passthru.
6
Disconnect modem from
timing mechanism.
Later VP Raveon Radio Kit
Installation Instructions
RISK OF ELECTRIC SHOCK.
4
Disconnect ground.
7
From opposite side,
remove mounting nuts.
1
Disconnect power
from radio interface board.
2
Disconnect wireline
connection from modem.
5
Disconnect
antenna cable.
8
Remove radio assembly.
Advertisement
Summary of Contents for Toro Later VP Raveon
- Page 1 Later VP Raveon Radio Kit Installation Instructions RISK OF ELECTRIC SHOCK. Before replacing the radio, be sure to disconnect power to the pedestal. Old Radio Removal Disconnect power from radio interface board. Disconnect wireline connection from modem. Disconnect ground. Disconnect Disconnect antenna cable.
- Page 2 The New Radio Kit standard modem connection TM connection jumpers power connection antenna connection New Radio Installation From opposite side, For VP controller, secure with nuts. all four jumpers should be Insert radio assembly. to the left. Connect to timing mechanism. Connect antenna cable.
- Page 3 • Radio Manager software from Raveon • USB to Serial (DB9) cable with included drivers • 12V Phoenix power connector (from authorized Toro distributor) • 12V power supply for radio (from authorized Toro distributor) Figure 2 To put the Raveon radio into bell202 mode: 1.
- Page 4 Changing the Frequency of the Radio At the time of installation, your authorized Toro installer should configure the radio to work properly. In the future, if it becomes necessary to change the radio frequency, follow the steps below. See Required Items, previous page.