Related Manuals for Philips D4550
Summary of Contents for Philips D4550
- Page 1 Always there to help you Register your product and get support at www.philips.com/support D4550 Question? Contact Philips Extended user documentation...
-
Page 3: Table Of Contents
Contents 7 Phonebook 8 Call log 1 Important safety instructions 9 Redial list 2 Your phone What is in the box 10 Phone settings Overview of the phone Sound settings Eco mode 3 Get started ECO+ mode Connect the charger Name the handset Install the supplied batteries Set the date and time... - Page 4 15 Frequently asked questions 16 Appendix Text and number input tables 17 Index...
-
Page 5: Important Safety Instructions
1 Important safety • Handsfree activation could suddenly increase the volume in the earpiece to a very high level: make sure instructions the handset is not too close to your ear. • This equipment is not designed to make emergency calls when the power fails. -
Page 6: Your Phone
2 Your phone Congratulations on your purchase and welcome Guarantee to Philips! To fully benefit from the support that Philips offers, register your product at www.philips. com/welcome. What is in the box Short user manual Overview of the phone Handset**... - Page 7 • Scroll up on the menu. • Access the main menu in standby • Increase the earpiece/speaker volume. mode. Confirm selection. • • Enter the options menu. • Delete text or digits. • Select the function displayed on the • Cancel operation.
-
Page 8: Get Started
3 Get started Caution • Make sure that you have read the safety instructions in the 'Important safety instructions' section before you connect and install your handset. Connect the charger Warning Install the supplied batteries • Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the phone. -
Page 9: Configure Your Phone (Country Dependent)
» The setting is saved. Caution • Risk of explosion! Keep batteries away from heat, Set the date and time sunshine or fire. Never discard batteries in fire. • Use only the supplied batteries. • Risk of decreased battery life! Never mix different Select [Menu] >... -
Page 10: Charge The Handset
When the handset is off the Note base station, the bars indicate the • If the PIN is incorrect or no base is found within a battery level (full, medium and certain period, your handset displays a notification low). message. Repeat the above procedure if registration When the handset is on the base fails. -
Page 11: Check The Signal Strength
• Make sure the handset is connected to the It remains steadily on when browsing base station before you make or receive incoming calls in the call log. calls and carry out the phone functions It remains steadily on when browsing and features. -
Page 12: Calls
9). Answer a call Make sure that all the handsets registered to the base station are Philips D45 models in When the phone rings, you can select from the order to have this feature functioning properly. following options: •... -
Page 13: Adjust The Earpiece/Speaker Volume
» The first call is put on hold. • Place the handset to the charging cradle. Dial the second number. » The number displayed on the screen is Note dialed out. • Placing the handset to the base station or charging cradle does not end the call when the auto hangup feature is turned off (see 'Activate/Deactivate auto Answer a second call... - Page 14 When you are connected to two calls, you can make a conference call in these ways: • Press , then ; or • Press [Option], select [Conference] and then press [OK] again to confirm. » The two calls are combined and a conference call is established.
-
Page 15: Intercom And Conference Calls
This feature is available for multi- handset versions only. call. Make sure that all the handsets registered to Switch between calls the base station are Philips D45 models in order to have this feature functioning properly. Press and hold to switch between the An intercom call is a call to another handset outside call and the intercom call. - Page 16 Press to end the conference call and transfer the existing call to the selected handset. Note • Press to join an ongoing conference with another handset if [Services] > [Conference] is set to [Auto]. During the conference call Press [Int.] to put the external call on hold and go back to the internal call.
-
Page 17: Text And Numbers
6 Text and numbers You can enter text and numbers for handset name, phonebook records, and other menu items. Enter text and numbers Press once or several times on the alphanumeric key to enter the selected character. Press [Clear] to delete a character. Press and hold [Clear] to delete all characters. -
Page 18: Phonebook
7 Phonebook Make sure that all the handsets registered to the base station are Philips D45 models in order to have this feature functioning properly. For more information, see the base station's user manual. -
Page 19: Call Log
8 Call log Make sure that all the handsets registered to the base station are Philips D45 models in order to have this feature functioning properly. For more information, see the base station's user manual. -
Page 20: Redial List
9 Redial list Make sure that all the handsets registered to the base station are Philips D45 models in order to have this feature functioning properly. For more information, see the base station's user manual. -
Page 21: Phone Settings
Make sure that all the handsets registered to Select [Menu] > [Phone setup] > the base station are Philips D45 models in [Sounds] > [Silent mode], then press order to have this feature functioning properly. [OK] to confirm. -
Page 22: Eco Mode
Set the battery tone ECO+ mode Battery tone is the sound made when the When the ECO+ mode is activated, it battery is low and needs recharging. eliminates the radiation of the handset and base Select [Menu] > [Phone setup] > station in standby mode. -
Page 23: Name The Handset
Select [On]/[Off], and select [OK] to Name the handset confirm. » The setting is saved. The name of the handset can be up to 14 characters. It is displayed on the handset screen in standby mode. Activate/Deactivate auto hang Select [Menu] > [Phone setup] > [Phone name], then press [OK] to confirm. -
Page 24: Alarm Clock
11 Alarm clock Your phone has a built-in alarm clock. Check the information below to set your alarm clock. Set the alarm Select [Menu] > [Alarm], then press [OK] to confirm. Select [On once] or [On daily], then press [OK] to confirm. Enter an alarm time, then press [OK] to confirm. -
Page 25: Services
You can block outgoing calls to numbers, such Make sure that all the handsets registered to as overseas calls or undesirable hotlines by the base station are Philips D45 models in barring calls that start with certain digits. You order to have this feature functioning properly. -
Page 26: Blacklist
Enter the old barring PIN/passcode. The Select [Blacklist], then press [OK] to confirm. default PIN is 0000. Then press [OK] to confirm. Enter the PIN/passcode. The default PIN is 0000. Then press [OK] to confirm. Enter the new PIN/passcode, then press [OK] to confirm. -
Page 27: Select The Recall Duration
6043338888, your phone changes the number Dial mode to 12503338888 when it dials out. Note Note • This feature only applies to models that support both • The maximum length of a detect number is 10 digits. tone and pulse dial. The maximum length of an auto prefix number is 10 digits. -
Page 28: Register Additional Handsets
Register additional handsets You can register additional handsets to the base station (see 'Register your handset' on page 7). Unregister the handsets Select [Menu] > [Services] > [Unregister], then press [OK] to confirm. Enter the system PIN. (The preset PIN is 0000). -
Page 29: Technical Data
Range outdoor: 300 meters Caller identification standard support: FSK, • DTMF Battery • Philips: 2 x AAA Ni-MH 1.2V 550 mAh rechargeable batteries Power adapter • MEIC: MN-A102-E130, input: 100-240 V~, 50/60 Hz 200 mA, output: 6 Vdc 400 mA •... -
Page 30: Notice
Directive 1999/5/EC. You can find the Declaration of Conformity on www.p4c.philips. com. This product has been designed, tested and manufactured according the European R&TTE This symbol on a product means that the directive 1999/5/EC. - Page 31 polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.
- Page 32 15 Frequently Telefon-Setup > Sprache Config. telef. > Lingua asked questions Select it to access the language options. Select your own language. The handset loses connection with the base No signal bar is displayed on the screen. or the sound is distorted during a call. •...
- Page 33 • The handset is nearly out of range. Move it closer to the base station. • The phone receives interference from the nearby electrical appliances. Move the base station away from them. • The phone is at a location with thick walls. Move the base away from them.
- Page 34 16 Appendix A B Г 2 A B C Æ Ä Å Ç Δ Ε Ζ 3 D E F É Η Θ Ι 4 G H I Κ Λ Μ 5 J K L Text and number input tables Ν...
- Page 35 m n o Ћ 6 Р С Т У p q r s Җ Š 7 Ф Х Ц Ч Π Θ Σ ß t u v Lj 8 Ш Щ Ъ Ы w x y z Ž 9 Ь Э Ю Я Ω Ξ Ψ...
- Page 36 17 Index language setting handset alarm auto answer auto clock auto conference mute auto hang up auto prefix name the handset battery network type blacklist phone settings call barring call list type blacklist calling call barring conference call 11, 13, 23 registration date setting 7, 25...
- Page 37 two calls/call on hold volume adjustment...
- Page 38 2015 © WOOX Innovations Limited. All rights reserved. 0168 Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used by WOOX Innovations Limited under license from Koninklijke Philips N.V. UM_D4550_12_EN_V1.0 wk1506...