Table of Contents
Advertisement
Error Message
Cause
An ink cartridge is not installed
No Cartridge
properly.
The memory card or USB Flash
No File
memory drive in the media drive
does not contain a .JPG file.
The machine is out of paper or
No Paper Fed
paper is not properly loaded in the
paper tray.
The paper is jammed in the machine. See Printer jam or paper jam on page 58.
The machine's memory is full.
Out of Memory
The memory card or USB Flash
memory drive you are using does
not have enough free space to scan
the document.
Paper is jammed in the machine.
Paper Jam
Print Unable XX The machine has a mechanical
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
Scan Unable XX The machine has a mechanical
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
Unusable Device A broken device has been
connected to the USB direct
interface.
56
Action
Take out the ink cartridge and put it in again
seating it properly. (See Replacing the ink
cartridges on page 60.)
Put the correct memorycard or USB Flash
memory drive into the slot again.
Do one of the following:
Refill the paper in the paper tray, and then
press Mono Start or Colour Start.
Remove the paper and load it again and then
press Mono Start or Colour Start.
Copy operation in progress
Press Stop/Exit and wait until the other
operations in progress finish and then try again.
Printing operation in progress
Reduce print resolution. (For details, see
®
Printing for Windows
or Printing and Faxing for
®
Macintosh
in the Software User's Guide on the
CD-ROM.)
Delete unused files from your memory card or
USB Flash memory drive to make some free
space and then try again.
Remove the Jam Clear Cover (at the back of the
machine) and pull out the jammed paper. (See
Printer jam or paper jam on page 58.)
Open the scanner cover and remove any foreign
objects inside the machine. If the error message
continues, disconnect the machine from the
power source for several minutes then
reconnect it.
Open the scanner cover and remove any foreign
objects inside the machine. If the error message
continues, disconnect the machine from the
power source for several minutes then
reconnect it.
Unplug the device from the USB direct interface,
then press On/Off to turn the machine off then
on again.
Advertisement
Table of Contents
