Table of Contents
Advertisement
New Connection Example 1 - Create a New PPPoE Connection
The example below describes how to set up a new connection that uses a PPPoE type WAN conneciton. To
create a new connection:
1. Click on the New Connection button.
2. Configure the Router for the Type: of conneciton used and all the remaining settings as discussed in the
preceding section. In this example, the type of connection used for Connection 2 is PPPoE. Notice also
the the VPI and VCI values have been changed.
3. Click the Apply button to cerate the new connection. Notice that a new menu button is created
(Connection 2), this links to the configuration menu for Connection 2 (see example below). If at any
time you want to change, delete, disconnect or connect this WAN connection, click on the Connection 2
button and make the changes in the Connection 2 menu.
4. Now save the changes you just made. Click the Tools tab and then click on the System Commands
button. Click on the Save All button to store the configuration settings. Click on Back button to return
to the System Commands menu.
Remember to save new configuration settings using the Save All button when you have
made all the intended changes. Go to Tools à System Commands à Save All.
Note
DSL-562T ADSL Router User's Guide
Figure 3- 11. Setup a New Connection – Connection 2
27
Advertisement
Table of Contents
