Advertisement
Attach the small tube bracket on the top of the printer to the right edge.
Install Tubing in Bracket and Adjust the Slack:
5. Put a little alcohol on the tubes at the position that will interface with the bracket.
For the 1270/1280/1290 printers, do not rotate the tubing. Slide the tubing into
the tube clip attached to the underside of the bridge bracket. This is the bracket
you installed in step #4. With the cartridges still in the left hand position, make
sure there is a little slack in the tubing, not a lot, but just enough. If you can't get
the tubing into the bracket, use a little more alcohol on the tubing.
Move the cartridges, by hand, from far left to far right. Make sure there is
sufficient slack in the tubing so that the cartridges can reach the far right and far
left with out putting excess tension in the tubes. If you have too much slack in the
tubes, then the tubing will touch the bottom of the printer. Adjust the tube
position in the bracket so the tubes don't touch the bottom of the printer, and so
the carts can reach far left and right with out the tubes stopping the motion. This
is important.
With the new bridge bracket, the bottom of the printer chassis and the underside
of the tubes must be coated with silicone lubricant. We have included a cotton pad
containing the silicone lubricant. Wipe the silicone on the inside metal base or
chassis (in the center) and on the bottom of the ink tubes. When the tubes touch
the metal part of the printer, they will slide and not stick. This is important.
S a v e
M o n e y
a n d
I m p r o v e
Y o u r
P r i n t i n g
MIS Associates Inc
2901 Auburn Rd
Auburn Hills, MI 48326
800-445-8296
http://www.inksupply.com
Fax: 248-289-6013
Email: sales@inksupply.com
Advertisement
