Fujitsu MAU3147RC Product/Maintenance Manual page 85

Index
A
AC noise filter .............................................. 4-8
actuator......................................................... 1-5
allowable input voltage and current .............. 4-7
alternate area ................................................ 3-9
alternate block allocation............................ 3-10
alternate block allocation by FORMAT
UNIT command .................................... 3-11
alternate block allocation by REASSIGN
BLOCKS command .............................. 3-12
alternate block allocation during
FORMAT UNIT command execution.... 3-11
alternate cylinder .......................................... 3-4
alternate spare area ....................................... 3-4
automatic alternate block allocation............ 3-13
automatic alternate block allocation at
read operation ....................................... 3-13
automatic alternate block allocation at
write operation ...................................... 3-13
automatic alternate block reassignment......... 1-3
B
basic operation test ....................................... 6-4
BCRC........................................................... 3-7
block address of user space ........................... 3-9
block descriptor ............................................ 5-5
C
cache feature ................................................ 1-3
caching parameter......................................... 5-9
changing revision number in field................. 6-8
checking at abnormal end ............................. 5-5
checking initial operation ............................. 5-4
checking operation after installation and
preparing HDD for use ............................ 5-4
command queuing feature............................. 1-3
compactness ................................................. 1-2
connection requirement ................................ 4-8
connector...................................................... 4-8
continuous block processing ......................... 1-2
control mode parameter ................................ 5-9
controller circuit ........................................... 1-5
current waveform.......................................... 4-7
cylinder configuration................................... 3-1
D
data field ...................................................... 3-7
data format ................................................... 3-1
C141-E222
data security at power failure ....................... 2-6
data space .................................................... 3-1
defect list ....................................................3-10
defect management .....................................3-10
defective block slipping ............................... 1-4
definition of sense data................................. 7-3
delivery........................................................ 5-2
diagnosis ...................................................... 1-4
diagnostic..................................................... 6-1
diagnostic test .............................................6-10
diagnostics and maintenance ........................ 6-1
dimension .................................................... 4-1
disk .............................................................. 1-5
disk drive replacement ................................. 6-7
disk drive troubleshooting ...........................6-13
disk read error .............................................. 7-4
dismounting drive .......................................5-10
dual SAS port support .................................. 1-2
E
ECC ............................................................. 3-7
environmental specification ......................... 2-4
environmental temperature........................... 4-5
environmental/power requirement ................ 2-4
error analysis................................................ 7-1
error analysis information collection ............ 7-1
error information indicated with sense
data......................................................... 7-3
error rate ...................................................... 2-5
error recovery............................................... 1-3
error recovery during self-diagnostic ............ 6-3
error recovery parameter .............................. 5-8
example of SAS system configuration.......... 1-6
external magnetic field................................. 4-6
F
factory maintenance ..................................... 6-7
field maintenance......................................... 6-7
finding possibly faulty part..........................6-14
format capacity ............................................ 3-8
format of extended sense data ...................... 7-2
format parameter................................... 5-5, 5-6
FORMAT UNIT command .......................... 5-6
formatting .................................................... 5-5
function specification................................... 2-2
G
gap............................................................... 3-7
general description ....................................... 1-1
IN- 1