Sanyo PLC-XP200L Owner's Manual page 70

Appendix
appears on the screen
The image is out of focus.
The image is not bright
enough.
The color is strange.
The image is Left/Right
reversed.
The image is Top/Bottom
reversed.
The image is distorted or
runs off.
Auto PC adjustment
function does not work.
Some displays are not
seen during the operation.
The setting does not
remain after turning off
power.
Power management
function does not work.
Image disappears
automatically.
Capture function does not
work.
Some menus cannot be
selected.
No sound
70
– Filter is out of scroll. Replace the filter cartridge with a new one promptly. (See pages
62 -63)
– Adjust the focus of the projector.
– Check Projection Lens to see if it needs cleaning.
Note: Moving the projector from a cool temperature location to a warm temperature
✔
location may result in moisture condensation on Projection Lens. In such cases,
leave the projector OFF and wait until condensation evaporates.
– Projecting from excessive slant angle to the screen may cause keystone distortion
and partial imperfect focus.
– Make sure the projection screen is at least 4.6' (1.4 m) away from the projector.
– Check if "Contrast" or "Brightness" are adjusted properly. (See page 49)
– Check if "Image level" is selected properly. (See pages 42, 46)
– Check the Lamp control function. ( See "SETTING" section on page 55)
– Check the LAMP REPLACE indicator. If it lights, the end of lamp life is approaching.
Replace the lamp with a new one promptly. (See page 64)
– Check the Input signal, color system, video system, or computer system mode.
– Adjust the Image Level properly. (See pages 42, 46)
– Check the Ceiling / Rear function. (See pages 44, 48.)
– Check the Ceiling function. (See pages 44, 48.)
– Check "PC Adjust" menu or " Screen" menu and adjust them.
– Check the Input signal. Auto PC Adjustment function cannot work when 480p, 575p,
720p, 480i, 575i, 1035i, or 1080i is selected or when the digital signal is input into DVI
terminal. (See page 39)
– Check the Display function (see page 52).
– Make sure you selected "Store" after adjusting settings. Some settings cannot be
stored if not registered with "Store" .
– Power management function cannot work while "Freeze" function is running or the
shutter is closed.
– Check the power management function in the Setting. The power management is set
to "On" at the factory.
– Check the connection to see if there is signal.
– Each of the Video Input and Computer Input has a limit on selectable menus.
– Check the audio cable connection from audio input source.
– Adjust the audio source.
– Press the Volume + button. ( See page 31)
– Press the Mute button. (See page 31)
– Is the image projected? You will hear the sound only when the image is projected.
– Make sure you selected correct Input pattern. (See page 31)