Rear Terminal
① CONTROL PORT
When the projector is controlled by a computer,
connect to this jack with serial control cable.
②
COMPUTER IN 1 / COMPONENT IN
Connect output signal from a computer, RGB scart
21-pin video output or component video output to
this terminal(pp.14,16).
③
COMPUTER IN / MONITOR OUT
– Connect computer output to this terminal (p.14).
– This terminal can be used to output the incoming
analog RGB and Component signal from
COMPUTER IN 1/COMPONENT IN terminal to the
other monitor (pp.14,16).
④
LAN Connection Terminal
Connect the LAN cable (refer to the owner's manual
of "Network Set-up and Operation").
⑤
S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.15).
①
②
L
⑧
⑨
Part Names and Functions
③
R
⑦
⑥
⑤
⑥ AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.14-16).
This terminal outputs sound from AUDIO IN
terminal (⑦ or ⑧).
⑦
COMPUTER 1 / COMPUTER AUDIO IN
Connect the audio output (stereo) from a
computer or video equipment connected to ②
or ③ to this jack. (pp14, 16)
⑧
AUDIO IN
Connect the audio output signal from video
equipment connected to ⑤ or ⑨ to this jack.
For a mono audio signal (a single audio jack),
connect it to the L (MONO) jack (p.15).
⑨
VIDEO IN
Connect the composite video output signal to
this jack (p.15).
④
9