Optical Drive Connector - HP ProBook 4430s Maintenance And Service Manual

Optical drive connector

Description
Optical drive connector
Before removing the optical drive connector, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Bottom door (see
b. Hard drive (see
c. Optical drive (see
d. WLAN module (see
e. WWAN module (see
f. Fan (see
g. Heat sink (see
h. Keyboard (see
i. Top cover (see
j. System board (see
Remove the optical drive connector:
1. Position the computer upright with the front toward you.
2. Lift the left side of the connector to disengage it from the computer (1).
Battery on page
Bottom door on page
Hard drive on page
Optical drive on page
WLAN/Bluetooth combo card on page
WWAN module on page
Fan on page 67)
Heat sink on page
Keyboard on page
Top cover on page
System board on page
48).
50).
53)
51)
57)
69)
64)
72)
93)
Component replacement procedures
Spare part number
646359-001
59)
101