I N S TA L L AT I O N I N S T RU C T I O N S READ ALL INSTRUCTIONS BEFORE INSTALLATION INSTALLATION SAFETY INSTRUCTIONS BEFORE YOU BEGIN Remove all tape and packing materials before using the range. Dispose all plastic bags after unpacking the range.
Page 3
I N S TA L L AT I O N I N S T RU C T I O N S READ ALL INSTRUCTIONS BEFORE INSTALLATION INSTALLATION SAFETY INSTRUCTIONS (continued) - If the range is pulled away from the wall for WARNING! cleaning, service, or any other reason, ensure that the Anti-Tip Device is properly reengaged when...
I N S TA L L AT I O N I N S T RU C T I O N S READ ALL INSTRUCTIONS BEFORE INSTALLATION INSTALLATION SAFETY INSTRUCTIONS (continued) WARNING • If a 30” clearance between cooking surface and •...
I N S TA L L AT I O N I N S T RU C T I O N S DIMENSIONS AND CLEARANCES Provide proper clearances between the range and The range may be placed with 0” clearance (flush) at adjacent combustible surfaces.
Page 6
I N S TA L L AT I O N I N S T RU C T I O N S LOCATION Do not locate your range where it may be subject When the floor covering ends at the front of the range to strong drafts.
I N S TA L L AT I O N I N S T RU C T I O N S GAS PIPE AND ELECTRICAL OUTLET LOCATIONS 30” Recommended area for 120V 2” outlet on rear wall and area for through-the wall connection of pipe stub and shut-off valve.
I N S TA L L AT I O N I N S T RU C T I O N S 2. CONNECT THE RANGE TO GAS Shut off the range gas supply valve before Connect flexible metal appliance connector to the removing the old range and leave it off until the adapter on the range.
I N S TA L L AT I O N I N S T RU C T I O N S 3. ELECTRICAL CONNECTIONS ELECTRICAL REQUIREMENTS 120 Volt, 60 Hertz, properly grounded dedicated circuit protected by a 15 or 20 Amp circuit breaker, or slow blow fuse.
I N S TA L L AT I O N I N S T RU C T I O N S 5. ASSEMBLE THE SURFACE BURNERS CAUTION DO NOT operate the burners without all parts in Hole place. Place the burner caps and heads on the cooktop. Electrode Make sure that the caps and heads are placed in the correct locations.
Page 11
I N S TA L L AT I O N I N S T RU C T I O N S 7. ADJUST THE SURFACE BURNER LOW FLAME(SIMMER) SETTING. 1) Light all surface burners. 2) Turn the knob on the burner being adjusted to “LO”.
Page 12
I N S TA L L AT I O N I N S T RU C T I O N S 8. CHECK OPERATION OF BAKE/BROIL BURNERS To check ignition of the Bake burner follow the steps To check ignition of the Broil burner follow the steps below: below: 1) Remove all packing from inside the oven cavity.
I N S TA L L AT I O N I N S T RU C T I O N S 10. INSTALLING THE ANTI-TIP DEVICE LOCATING THE BRACKET USING THE WARNING TEMPLATE. • Range must be secured with an approved Anti- Tip device.
I N S TA L L AT I O N I N S T RU C T I O N S WHEN ALL HOOKUPS ARE COMPLETE Make sure all controls are left in the off position. Make sure the flow of combustion and ventilation air to the range is unblocked.
Page 15
• Check to be sure that no range parts have come loose during shipping. To contact LG Electronics To contact LG Electronics Para comunicarse con LG Electronics Para comunicarse con LG Electronics 24 hours a day, 7 days a week: 24 hours a day, 7 days a week: 24 horas al día, 7 días a la semana:...