Beko GNE 46102 E Manual page 13

Connection of the Water Pipe to
the Cold Water Mains Line
1.
Separate the nut from the tap adaptor.
Figure A)
(
2.
As shown in the figure, assemble the tap
adaptor to 1/2" valve fitting (
3.
As shown in the figure, after inserting the
water pipe to the nut, install it to the tap adaptor
and insert to the tap as shown in the figure.
Figure C)
(
4.
Tighten the nut manually. In case of a leak
use a spanner or a pair of pliers to tighten the
nut.
Tap Adaptor
Main Cold Water Line
Feed
Valve
Figure B)
Mesh Filter
Nut
Figure A
Tap
Adaptor
Figure B
Caution:
Secure the water pipe to suitable
points by means of the pipe clips supplied to
avoid any damage or displacement or
accidental disconnection.
Caution:
After turning on the water valve,
make sure that there is no leakage at both
connection points of the water pipe. In case
of a leak, turn off the valve immediately and
tighten all joints again using a spanner or a
pair of pliers.
EN
11
Tap
Adaptor
Nut
Water Tube
Figure C