9.
Load any necessary drivers.
NOTE:
search for your specific thin client model.
10.
Reconfigure the thin client, if necessary.
Removing and Replacing the Side Access Panel
Removing the Side Access Panel
WARNING!
power cord is disconnected from the electrical outlet.
To remove the access panel:
1.
Lay the unit flat on a stable surface with the right side up and the left side down.
2.
Remove the two screws that secure the access panel to the chassis (1).
3.
Slide the access panel about 8.3 mm (1/3 inch) toward the rear of the unit (2), and then lift the
access panel up and off the unit (3).
Figure 2-1
8
Chapter 2 Hardware Changes
You can download select hardware drivers from HP. Go to
Before removing the side access panel, ensure that the thin client is turned off and the
Removing the side access panel
http://www.hp.com
and