Table of Contents
Advertisement
Replacing the internal clock battery
This projector has internal clock that uses a battery. When the clock of the network
function does not work correctly, please try solution by replacement of the battery:
HITACHI MAXELL, part number CR2032 or CR2032H.
1.
Turn the projector off, and unplug the
power cord. Allow the projector to cool
2.
After making sure that the projector has
cooled adequately, slowly turn over the
projector, so that the bottom is facing.
3.
Turn the battery cover fully in the direction
and pick the cover up to remove it.
4.
screwdriver or the like to take it out. While
battery since it may pop out of the holder.
5.
Replace the battery with a new HITACHI
MAXELL, Part No. CR2032 or CR2032H.
Slide the battery in under the plastic claw,
and push it into the holder until it clicks.
6.
Replace the battery cover in place, then
NOTE
WARNING
environment pollution.
such as a scratch, a dent, rust or leakage.
When a battery leaked, wipe the leakage out well with a waste cloth. If the
leakage adhered to your body, immediately rinse it well with water. When a battery
leaked in the battery holder, replace the batteries after wiping the leakage out.
battery.
or water.
a battery. If swallowed consult a physician immediately for emergency treatment.
16
90°
17, 19)
(
OPEN
CLOSE
90°
Advertisement
Table of Contents
