Advertisement
TH-A5R
<DVD mechanism assembly section>
Removing the DVD loader board
Prior to performing the following procedure, remove
the top cover and DVD mechanism assembly.
1.
Disconnect the card wire from the connector J6 on
the DVD MPEG board.
2.
Disconnect the harness from the connector on the
motor board.
3.
Disconnect the harness from the connector J5 on the
DVD loader board.
4.
Remove the four screws A attaching the DVD loader
board to DVD mechanism assembly.
CAUTION!!
Before removing the card wire which
connects the pickup board and DVD loader
board, solder the two soldering parts and
make it short-circuit.
Moreover, while having removed the card
wire, don't remove these solder.
5.
Disconnect the card wire from the connector U9 on
the DVD loader board.
ONE POINT
How to eject the DVD tray manually
The white lever of the
the direction of the arrow. Then, the tray will
be opened.
Moreover, the tray is separable from a DVD
mechanism assembly by removing two
screws of the
mark (see fig.1) and drawing
out the tray.
Removing the DVD loading mechanism
Prior to performing the following procedure, remove
the top cover, DVD mechanism assembly and DVD
loader board.
1.
Remove the two screws B and remove the bracket.
2.
Remove the one screw C fixing the DVD loading
mechanism.
3.
Move the lever in the direction of the arrow X.
4.
Remove the DVD loading mechanism from the DVD
mechanism assembly by moving it in the direction of
the arrow Y.
1-10
(See Fig.1 to 3)
(see fig.3)
(see fig.2)
mark is moved in
(See Fig.4)
DVD MPEG board
J6
Fig.1
DVD loader board
A
U9
J5
Fig.2
Pick up
Soldering parts
board
Fig.3
B
X
Lever
Y
C
Fig.4
DVD mechanism assembly
(top side)
DVD mechanism assembly
(bottom side)
Motor board
Connector
Motor board
DVD loading
mechanism
DVD mechanism assembly
(bottom side)
Bracket
DVD loading
mechanism
Advertisement
