Advertisement
Connecting the Monitor
On the back of the monitor are two plug-in connections; one for the AC
power cord, and the other for the signal cable from the video card.
1
Power off both the monitor and PC.
2
Connect the 15 pin VGA connector of the supplied signal cable to the output
VGA video connector on the PC and the matching input connector on the rear
of the monitor. The connectors will mate only one way. If you cannot attach
the cable easily, turn the connector upside down and try again. When mated,
tighten the thumbscrews to secure the connection.
2'
Locate the appropriate MAC to VGA adapter block at your local computer
store. This adapter changes the high density 3 row 15 pin VGA connector to
the correct 15 pin 2 row connection to mate with your MAC. Attach the other
end of the signal cable to the side of the adapter block with 3 rows.
Connect the attached adapter block/signal cable to the video output on your
MAC.
3
Connect the plug from the AC-DC adapter into the connector on the display
1
unit.
Connect one end of the AC power cord into the AC-DC adapter.
Plug the other end into a properly grounded three-prong AC outlet.
4
Power on the PC, then the monitor.
5
If you see the NO SIGNAL message, check the signal cable and
connectors.
6
After using the system, power off the monitor, then the PC.
3
Power Cord
D-15P
1
2
AC-DC adapter
A2
IBM PC
MACINTOSH
Mac Adapter
2
D-15P
Signal Cable
* NOTE : If you see the "OUT OF
RANGE" message, check to make
sure your system is set to one of the
factory preset modes.(see page A8)
2
3
2'
Advertisement
