Location Requirements; Air Purifier Use; Starting/Stopping Your Air Purifier - Whirlpool WHISPURE Use & Care Manual

1. 6 in. (15.2 cm) min. clearance
NOTE: Before operating the air purifier, record the date of installation on the HEPA filter, which should be replaced annually. The pre-
filter should be replaced every 3 months. To remove and replace either filter, see "Filter Replacement" in the "Air Purifier Care" section.
Using the controls
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
2. Press POWER to start the air purifier. An indicator light will
turn on.
3. Press POWER to stop the air purifier. The indicator light will
turn off.
4

Location Requirements

1

AIR PURIFIER USE

Starting/Stopping Your Air Purifier

You will need a level surface at least 6 in. (15.2 cm) from heat
sources such as ranges or heaters.
Do not block air openings or place the air purifier on a soft
surface such as a bed or sofa.
Operate indoors only.
Fan Speed
Press FAN SPEED until the indicator light comes on for the
desired speed.
FAN SPEED RESULT
Low Best product sound
Medium Slower cleaning power
High Moderate cleaning power
Turbo Maximum cleaning power
Sleep Mode
Press SLEEP MODE to set. Sleep mode runs on Low fan speed
for 8 hours and then returns to previously selected setting. To exit
before 8 hours, press SLEEP MODE, FAN SPEED, or POWER.
Control Lock
The Control Lock locks the controls to prevent unintended
changing of the settings when the air purifier is on or off.
1. Press and hold SLEEP MODE for 5 seconds to lock. The
Control Lock indicator light will turn on. (No selection can be
made.)
2. Press SLEEP MODE for 5 seconds to unlock. The Control
Lock indicator light will turn off. (Now selections can be made
and the unit can be turned on or off.)
Filter Status Lights
The pre-filter and HEPA filter status lights will help you know
when to change your filters. The green status lights will move
from New to Replace at preset intervals. When the red Replace
status light is flashing, replace the filter as indicated. See "Filter
Replacement" in the "Air Purifier Care" section.