Method Of Software Upgrading Instructions - Sanyo LED-42XR10FH Service Manual

Method of software upgrading instructions

Factory software burned instructions listed as Table 7
Loc.
Model Part No.
No.
N103 5272564002
N106 5272404002
<26"
CCFL
N301
5272402002
N316
N305 5272402002
N103 5272564002
N106 5272404002
<26"
LED
N301
5272402002
N311
N305 5272402002
N103 5272564002
N106 5272404002
≥26"
N302
LED
N305 5272402002
N316
N309 5272402002
Note 1: Method of write-protect setup: enter into burning interface of ALL-100, tick option "Config",
press item "config Setting", set option "Protect" as "All Protect"; make sure that option "Config"
must be ticked before burning software and write-protect must be reset after ALL-100 burning
software is opened every time.
Note 2: Method of burning and upgrading software online by using ISP burning device:
a) For main board upgrade: connect 4-pin cable of ISP burning device to Debug port of main board
(<26": X404, ≥26": X604); for unit upgrade, connect both D-SUB ports of ISP burning device and
main board, enter into factory menu and set item "Other Settings->ISP Mode" as "ON";
b) Using Mstar online burning program, enter into menu "Device", tick option "WP Pin pull to high
during ISP" to ensure that hardware write-protect of Flash is removed and erasing process is
normal, please refer to Fig. 2;
Table 7 Factory software burned instructions
Part Type
EN25Q64-104HIP
AT24C04IV-10SU-2.7
AT24C02BN10SU-1.8
AT24C02BN10SU-1.8
EN25Q64-104HIP
AT24C04IV-10SU-2.7
AT24C02BN10SU-1.8
AT24C02BN10SU-1.8
EN25Q64-104HIP
AT24C04IV-10SU-2.7
AT24C02BN10SU-1.8
AT24C02BN10SU-1.8
Burned
Software
before
function
SMT
Main
Yes
program
HDCP
Yes
KEY
HDMI
Yes
EDID
VGA
Yes
EDID
Main
Yes
program
HDCP
Yes
KEY
HDMI
Yes
EDID
VGA
Yes
EDID
Main
Yes
program
HDCP
Yes
KEY
HDMI
Yes
EDID
VGA
Yes
EDID
Burning method
Use ALL-100 with write-protect,
refer to Note 1 in detail.
Use ALL-100, etc.
Use ALL-100, etc.
Use ALL-100, etc.
Use ALL-100 with write-protect,
refer to Note 1 in detail.
Use ALL-100, etc.
Use ALL-100, etc.
Use ALL-100, etc.
Use ALL-100 with write-protect,
refer to Note 1 in detail.
Use ALL-100, etc.
Use ALL-100, etc.
Use ALL-100, etc.