Table of Contents
Advertisement
11.4. Disassembly of FC (Freezer
Compartment)
SENSOR FC
11.4.1.
1. Take Case FCT A'ssy and Case FCB A'ssy out of FC.
2. Take Glass Tray FCT and Glass Tray FCB out.
a. Remove the screws that are fixation of Holder
Glass. (Each of two FC right and left)
b. Remove Holder Glass and pull Glass Tray FCT
and Glass Tray FCB out.
• The figure is left side view also there are Holder
Glass R in the right side.
3. Take Cover Connector FC out.
a. Remove the screw that is fixation of Cover Con-
nector FC on the left of upper side of FC.
b. Pull Cover Connector FC towards you, unhook the
Hooks (4 portions).
c. Remove sensor FC from the hook of reverse side
of Cover Connector FC, pull out the connector for
Fan Motor FC.
4. Cut the wire at near the Sensor FC.
5. Connect new Sensor FC and wires by Scotch Lock.
NOTES ON INSTALLATION
• Hook Sensor FC to the hook of Cover Connector FC as
before, store Sensor FC and Scotch Lock reverse side
of Cover Connector FC.
• Connect the connector of Fan Motor FC securely, store
the connector to the hook reverse side as before.
• Insert Cover Connector FC in upper side of FC as
before, screw the screws that are fixation of it.
THE POINT OF WORK
1. Insert deeply each wire one by one in Scotch Lock.
• The Scotch Lock is the structure that can connect
unstripped wires. Then it is unnecessary to use wire
stripper. (When you connect wires that was peeled
off film, it is easy to come off them.)
37
Advertisement
Table of Contents
