Advertisement
DISASSEMBLY- AND RE-ASSEMBLY ADVISE
Disassembly information
To remove the brew chamber lid cover handle as follows:
- Place the screwdriver on the
positions (see picture 1) and
lift the cover over the snap
locks on both positions.
- The cover lid can now be lifted
up a little and to remove the
complete cover including lever
and push rod squeeze strongly
with two fingers both legs of
the push rod (see picture 2)
to each other, so that the two
pins will get out of the hinge
position on the brew chamber.
- To remove lever from lid cover, take a screwdriver and bend
carefully the two lips/ribs in the lid cover outwards and
push the lever with force out of the hinge.
- Reassemble follow steps backwards, without using a
screwdriver.
To remove the back cover handle as follows:
- Remove valve outlet.
- Start at the upper side of the back cover and stick a
screwdriver into the 2 snap locks positions and gently pull
the back cover from the appliance so that a little chink
between back cover and brew chamber becomes visible.
- Put the screwdriver in to the 4 rectangular holes (snap
locks) at the back and gently pull the screwdriver such away
that the lips of the snap locks are bent outwards.
- If all clicks positions are loose, it is possible to remove the
back cover.
- Reassemble follow steps backwards.
Removing 3-way valve (item 9 exploded view) handle as
follows:
- Unsnap boiler out of brew chamber.
- Rotate the 3-way valve a quarter (90°) counter clockwise.
- Gently pull the 3-way valve out of the boiler.
- Reassemble follow the above steps backwards.
Removing Brew chamber head handle as follows:
- Back cover and 3-way valve must be disassembled!
- Place the appliance such a way that you are looking at the
- First remove the boiler from the snap lock position of the
- To do so use a screwdriver and bend slightly the both ribs to
picture 1
- To remove the brew chamber,
picture 2
- Reassemble follow above steps backwards.
To reach the components placed on the base handle as
follows:
- First remove back cover, brew chamber and 3-way valve.
- Remove both Torx T15 screws see exploded view in the near
- Bend the 2 click snap locks with a screwdriver (see base),
- To remove the rest of the housing unlock the last 4 snap
- To reassemble follow above steps backwards.
REPAIR INSTRUCTION
Descaling
Regular descaling will prolong the life of your appliance and
will guarantee optimal brewing results for a long time.
- Follow the steps in the section headed "Preparing the
- In stead of only water use a mix of water and Lemon sour.
- For the best result leave the mix of water and Lemon sour
- To get the best results repeat above mentioned step once or
- When finished, flush the appliance twice by repeating the
OPTIONAL (accessories)
- XL watertank (10 Cups)
boiler.
brew chamber.
(there were the boiler is fixed to the brew chamber)
the outer side and pull the boiler out of the fixation point.
use your both thumbs (see
picture 3) and push strongly
with a little distortion
(rotation) until the brew
chamber comes loose.
of position A.
and the housing can now be removed.
locks at the base and gently pull of the front cover.
appliance for use" see DFU (Direction For Use manual).
for about 30 minutes in the appliance, before you start with
flushing the appliance.
twice.
above mentioned steps only use water instead.
Commercial type number HD7982
Service code : 4222 259 20100
HD7810/80
picture 3
2-4
Advertisement
