Installing The Wheels; Installing The Handle - Toro 38535 Operator's Manual

Installing the Wheels

1. Turn the snowthrower onto its left side and place a
wood block under the left axle end (Fig. 2).
1
2
Figure 2
1. Pushnut
2. Slide the short spacer and a wheel onto the right axle
end (Fig. 2).
Note: The side of the wheel with 6 spokes must face
downward.
3. Slide a pushnut onto the end of the axle (Fig. 2).
4. Strike the pushnut with a hammer to seat it firmly in
place.
5. Turn the snowthrower over onto its right side and place
a wood block under the right axle end.
6. Slide the long spacer and a wheel onto the left axle end
(Fig. 3).
2
1
Figure 3
1. Long spacer
Note: The side of the wheel with 6 spokes must face
downward.
7. Repeat steps 3 and 4.
2. Short spacer
m-4499
2. Pushnut

Installing the Handle

1. Cut the plastic tie that secures the control cable to the
handle (Fig. 4).
1
2
Figure 4
1. Handle
2. Plastic tie
Important
If you do not cut the plastic tie, the rotor
brake will not function properly.
2. Position the upper handle as shown in Figure 5.
Figure 5
1. Upper handle
3. Loosely install the handle locks, curved washers, and
knobs as shown in Figure 6.
8
3
3. Control cable
1