JVC RX-D301S Service Manual page 10

3.1.4 Removing the tuner
(See Fig.6)
• Remove the top cover.
(1) Disconnect the card wire from the connector
tuner.
(2) From the back side of the main body, remove the two
screws G attaching the tuner to the rear panel and take out
the tuner.
3.1.5 Removing the subwoofer board
(See Fig.6)
• Remove the top cover.
(1) Disconnect the wire from the connector
woofer board.
(2) From the back side of the main body, remove the screw H
attaching the subwoofer board to the rear panel and take
out the subwoofer board.
3.1.6 Removing the front video board
(See Fig.6)
• Remove the top cover.
Reference:
Remove the tie band bundling the wires.
(1) Disconnect the wire from the connector
ume board
(2) From the back side of the main body, remove the two
screws J.
(3) Remove the nut and washer attaching the coaxial connec-
tor to the rear panel.
(4) Take out the front video board from the main body.
3.1.7 Removing the compulink board
(See Fig.6) [For Australia]
• Remove the top cover.
(1) Disconnect the wire from the connector
pulink board.
(2) From the back side of the main body, remove the screw K
and take out the compulink board from the main body.
1-10 (No.MB479)
[For Australia]
CN1 on the
CN524 on the sub-
Compulink board
CN662 on the vol-
[For Europe]
CN565 on the com-
Volume board Tuner
Front video board
CN662
CN565
Rear panel
K
Rear panel
Coaxial connector
Tuner
Volume board
Front video board
CN662
Rear panel
Coaxial connector
Fig.6
Subwoofer board
CN524
CN1
J G H
Nut and washer
Subwoofer board
CN524
CN1
J G H
Nut and washer