Table of Contents
Advertisement
•
bezel
3.
Open the
front bezel
4.
To remove the power switch:
a. Disconnect the power switch cable from the system board [1].
b. Unroute the power switch cable from the retention clip.
c. Press the release tab [2] and slide the power switch out of the computer [3].
Installing the power switch
1.
Insert the power switch into the slot and press it until it clicks into place.
2.
Route the power switch cable through the cable retention clip.
3.
Connect the power switch cable to the connector on the system board.
4.
Close the front bezel door.
5.
Install the:
•
bezel
•
cover
6.
Follow the procedure in
Removing the coin cell battery
1.
Follow the procedure in
2.
Remove the:
•
cover
•
bezel
3.
Open the
front bezel
4.
To remove the coin cell battery:
a. Remove the coin cell battery from the system board.
Installing the coin cell battery
1.
Hold the coin cell battery with the "+" sign facing up and slide it under the securing tabs at the positive side of the connector.
2.
Press the battery into the connector until it locks into place.
3.
Close the front bezel door.
4.
Install the:
•
bezel
•
cover
5.
Follow the procedure in
Removing the heat sink assembly
1.
Follow the procedure in
2.
Remove the:
•
cover
•
bezel
3.
Open the
front bezel
4.
To remove the heat sink assembly:
a. Disconnect the heat sink assembly cable from the connector on the system board [1].
b. Loosen the captive screws that secure the heat sink assembly to the system board [2, 3, 4, 5].
c. Lift the heat sink assembly away from the computer [6].
12
door.
After Working Inside Your
Before Working Inside Your
door.
After Working Inside Your
Before Working Inside Your
door.
Computer.
Computer.
Computer.
Computer.
Advertisement
Table of Contents
