Play In Group Mode - Philips BM7 User Manual

1
Connect an audio cable with a 3.5 mm
connector on both ends to
• the AUDIO IN socket on the speaker,
and
• the headphone socket on the external
device.
2
Press SOURCE repeatedly to switch to
the AUDIO IN source.
» The AUDIO IN indicator lights up
white.
3
Play music on the external device (refer to
its user manual).

Play in group mode

Group mode: If you have more than one
izzylink-compatible multiroom speakers, you can
create a group and stream music to the group
of speakers at the same time.
To use this feature, you need to purchase
more than one izzylink-compatible multiroom
speakers.
Note
•
You can create a group of up to five speakers, with one
as the master and four as slaves.
Create a group
5 sec.
Note
•
Whenever you create a group, the first speaker that
you enable the group function will act as the master.
1
Hold GROUP on the first speaker for
3 seconds (The master).
2
Hold GROUP on a second speaker for
3 seconds (The slave).
3
Wait for 15 to 30 seconds for connection
setup.
4
Repeat steps 1 to 3 to add more slave
speakers one by one.
Note
•
You can only add slave speakers one by one. Each time
when you add a slave speaker, first press and hold
GROUP on the master speaker until the indicator on
the button flashes and the speaker beeps.
•
If the signal strength indicator on a slave speaker shows
that the signal is poor, move it closer to the master
speaker.
You can add any of the following speakers into
the existing group or create a new group with
them:
• A speaker with factory default settings
• A master speaker that has no slave
connected to it
• A slave speaker that is disconnected
from its master (with the GROUP
indicator flashing)
5 sec.
EN 9