Lenovo RackSwitch G8264 Installation Manual page 52

52
RackSwitch G8264 Installation Guide
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
Appareil À Laser de Classe 1
To install a QSFP+ optical transceiver in a QSFP+ port, complete the following
steps.
Note: To avoid damage to the cable or the QSFP+ transceiver, do not connect the
cable before you install the transceiver.
1. Remove the safety cap and pull the locking lever into the down (unlocked)
position.
2. Insert the transceiver into the port until it clicks into place. Use minimal
pressure when you insert the transceiver into the slot. Do not use excessive
force when you insert the transceiver or you might damage the transceiver or
the QSFP+ slot.
The transceiver has a mechanical guide key to prevent you from inserting the
transceiver in an incorrect orientation.
3. Pull up the locking lever to lock the transceiver into place.
4. Connect the fiber-optic cable following the
To remove a QSFP+ optical transceiver, disconnect the fiber-optic cable, and pull
down the locking lever to release the transceiver. After you remove the transceiver,
replace the safety cap.
"Cabling Guidelines" on page 34.