Toro 71209 Operator's Manual page 37

12. Remove and inspect the spark plug; refer to Servicing
the Spark Plug on page 26. With the spark plug
removed from the engine, pour 2 tablespoons of engine
oil into the spark plug hole. Use the electric starter to
crank the engine and distribute the oil inside the
cylinder. Install the spark plug, but do not connect the
wire to the spark plug.
13. Disconnect the negative battery cable. Clean the battery
and battery terminals. Check the electrolyte level and
charge it fully; refer to Servicing the Battery on
page 22. Leave the negative battery cable disconnected
from the battery during storage.
Important
The battery must be fully charged to prevent
it from freezing and being damaged at temperatures below
32°F (0°C). You can store a fully charged battery during the
winter without recharging.
14. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is worn or damaged.
15. Paint all scratched or bare metal surfaces with paint
available from an Authorized Service Dealer.
16. Store the tractor in a clean, dry garage or storage area.
Remove the ignition and KeyChoice keys from the
mower and keep them in a memorable place. Cover the
tractor to protect it and keep it clean.
37