Setup; Adjusting The Rops; Checking The Tire Pressure - Toro 31230N Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Media and Additional Parts
Description
Operator's Manual
Engine Operator's Manual
Parts Catalog
Operator Training Material
1

Adjusting the ROPS

No Parts Required
Procedure
1. Remove the hairpin cotter pins and the pins from the
roll bar (Figure 3).
2. Raise the roll bar to the upright position and install
the two pins and secure them with the hairpin cotter
pins (Figure 3).
Note: If you must lower the roll bar, push the bar
forward to relieve pressure on the pins, remove the
pins, lower the bar slowly, and secure it with the pins so
that it does not damage the hood.
Description
No parts required
No parts required
No parts required
Qty.
–
–
–
Qty.
1 Read before operating the machine
1
Read before operating the machine
1 Use reference part numbers
1 View the video before operating the machine
1. Roll bar
2. Pin
11
Use
Adjust the ROPS
Check the tire pressure.
Check the hydraulic fluid, engine oil,
and coolant levels.
Use
Figure 3
3. Hairpin cotter pin