Setting The Signal - Siemens WM SERIES Instruction Manual And Installation Instructions

Setting the signal

en
M
Setting the signal
S e t t i n g t h e s i g n a l
1. Activate the setting mode for the signal volume
Set to Ú.
2. Set the volume for the button signals (depending on the model)
Press the button repeatedly until the
desired volume is reached.
3. Set the volume for the information signals
Turn the dial one position to the right. Press the button repeat-
28
Press and hold the 0 button and turn one
position to the right.
Go to point
3 or
edly until the desired vol-
ume is reached.
Set to Ú to exit the setting mode for the signal volume.
Set to Ú to exit the setting mode for
the signal volume.
Press and hold the button for
approx. five seconds until the
display elements light up. Set-
ting mode is activated.