Toro 30447 Operator's Manual page 35

Traction Unit
Service Interval: Every 50 hours
• Brake shaft pivot bearings (5) (Figure 37)
• Traction pedal pivot bushing (1) (Figure 38)
• Front and rear axle pivot bushings (2) (Figure 39)
• Steering cylinder ball joints (2) (Figure 40)
• Tie rod ball joints (2) (Figure 40)
• King pin bushings (2) (Figure 40).
The top fitting on the king pin should
only be lubricated annually (2 pumps).
Figure 37
Figure 38
Figure 39
Center Cutting Unit
Note: Deck may have to be raised to expose the grease
fittings for the latch pivot and the lower link.
• Latch pivot (2) (Figure 42)
Note: The latch (Figure 41) may need to be
manually tripped to gain access to the grease fitting.
Use a prybar to close and re-open the latch
1. Latch
35
Figure 40
Figure 41