Brake - Toro 71209 Operator's Manual

Maintenance
Set pressure to 20 psi (138 kPa) (tires with
markings of "Kenda", "Super Turf") for
tractors with serial numbers 9905001 and
up.
Figure 14
1. Valve stem

Brake

The brake is on the right side of the rear axle, inside
the rear tire (Fig. 15). If the brake does not hold
securely or stopping power is insufficient, an
adjustment is required.
Checking the Brake
1. Park the machine on a level surface, disengage
the blade control (PTO), shift into neutral, set
the parking brake, and turn the ignition key to
"OFF" to stop the engine.
2. If the rear wheels lock and skid when you push
the tractor forward, no adjustment is required.
An adjustment is required if the wheels turn and
do not lock; refer to Adjusting the Brake,
page 22.
22
Adjusting the Brake
1. Check the brake before you adjust it; refer to
Checking the Brake, page 22.
2. To increase braking resistance, tighten the brake
adjusting nut (Fig. 15) 1/8 turn clockwise; then
check the brake again. Continue this adjusting
and checking process until the brake is set
1
properly.
3. Push down on the clutch/brake pedal to release
the parking brake.
IMPORTANT: With the parking brake
released, the rear wheels must rotate freely
when you push the tractor. If the brake seems
m–1872
to "drag," loosen the adjusting nut slightly
until the wheels rotate freely. If both
conditions cannot be achieved, contact an
authorized service dealer immediately.
1. Brake adjusting nut
1
Figure 15
m–1895