Table of Contents
Advertisement
Fuse: Main F1—30 amp, blade-type
Charge Circuit F2—25 amp, blade-type
Optional Headlight Kit—10 amp, blade type
1. Raise the seat to gain access to the fuse holder (Fig. 61).
4
5
Figure 61
1. Main—30 amp
2. Charge circuit—25 amp
3. For optional Headlight
Kit—10 amp
2. To replace a fuse, pull out on the fuse to remove it
(Fig. 61).
Servicing the Battery
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Checking the Electrolyte Level
1. Shut off the engine and wait for all moving parts to
stop.
2. Open the hood.
3. Look at the side of the battery. The electrolyte must be
up to the upper line (Fig. 62).
1
2
3
m–7724
4. Ignition switch
5. Throttle lever
44
1
2
3
Figure 62
1. Filler caps
2. Upper line
Note: Do not allow the electrolyte to get below the
lower line (Fig. 62).
4. If the electrolyte is low, add the required amount of
distilled water; refer to Adding Water to the Battery on
page 45.
Installing the Battery
1. Position the battery in the tray with the terminal posts
toward the engine (Fig. 63).
9
11
7
10
1
Figure 63
1. Battery
2. Terminal boot
3. Positive battery cable
4. Negative battery cable
5. Ground wire
6. Bolt, 1/4 x 3/4 inch
2. First, install the positive (red) battery cable to the
positive (+) battery terminal.
m–5004
3. Lower line
5
4
2
6
7
3
8
m–5598
7. Washer, 1/4 inch
8. Locknut, 1/4 inch
9. Battery clamp
10. J-bolts
11. Wing nut, 1/4 inch
Advertisement
Table of Contents
