Servicing The Battery - Toro 72201 Operator's Manual

5. Push and rotate the bulb counterclockwise until it stops
(approx. 1/4 turn) and remove bulb from the bulb
holder (Fig. 36).
5
3
2
4
Figure 35
1. Bulb holder
2. Reflector
3. Tabs
Installing the Bulb
1. The bulb has metal pins on the side of its base. Align
the pins with the slots in the bulb holder and insert the
base into the holder (Fig. 36). Push and rotate the bulb
clockwise until it stops.
2
4
3
Figure 36
1. Bulb
2. Metal pins
2. The bulb holder has two tabs (Fig. 35). Align the tabs
with the slots in the reflector, insert the bulb holder
into the reflector and rotate it 1/4 turn clockwise until
it stops.
3. Push the wire connectors onto the terminals on the
bulb holder.
5
1
4
4. Slots
5. Terminals
1
2
4
3. Bulb holder
4. Slots
31

Servicing the Battery

Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Service Interval/Specification
Always keep the battery clean and fully charged. Use a
paper towel to clean the battery case. If the battery
terminals are corroded, clean them with a solution of four
parts water and one part baking soda. Apply a light
coating of grease to the battery terminals to prevent
corrosion.
Voltage: 12 v, 340 Cold Cranking Amps
Removing the Battery
Warning
Battery terminals or metal tools could short
against metal tractor components causing sparks.
Sparks can cause the battery gasses to explode,
resulting in personal injury.
When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the tractor.
Do not allow metal tools to short between the
battery terminals and metal parts of the
tractor.
Warning
Incorrect battery cable routing could damage the
tractor and cables causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
Always disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
Always reconnect the positive (red) battery
cable before reconnecting the negative (black)
cable.
1. Disengage the PTO and set the parking brake.