Operation - Toro 38535 Operator's Manual

Mixing Gasoline and Oil
This snowthrower uses a 50:1 gasoline-to-oil mixture.
Use Toro 50:1 2-Cycle Oil (Fuel Stabilizer Added)
or an equivalent high-grade, NMMA TCW-certified
two-cycle oil.
Important: To prevent engine damage, do not use
automotive oil (such as SAE 30 or 10W30) or fuel
mixed at the wrong gasoline-to-oil ratio.
1. Pour a half US gallon (1.9 liters) of fresh,
unleaded gasoline into an approved fuel container.
2. Add two-cycle oil to
the gasoline according
to the chart below:
50:1 Gasoline-to-Oil Ratio Mixing Chart
Gasoline
1 US gallon (3.8 liters)
2 US gallons (7.6 liters)
3. Install the cap on the fuel container.
4. Shake the container to mix the gasoline and oil
thoroughly.
5. Slowly remove the cap and add the remaining
amount of gasoline.
Note: Do not mix gasoline and oil in the fuel tank. Oil
at room temperature mixes easier and more
thoroughly than cold oil. Oil below 32 F (0 C) requires
additional mixing.
Filling the Fuel Tank
Fill the fuel tank with a fresh mixture of gasoline and
oil mixed at the proper ratio.
7
m-6188
Oil
2.6 ounces (80 ml)
5.2 ounces (160 ml)
m-6106
3329-453

Operation

Note: Determine the left and right sides of the
machine from the normal operating position.
Starting the Engine
1. Turn the ignition key
clockwise to the On
position.
2. Move the choke
lever to the right.
3. Firmly push in the
primer 2 times with your
thumb, holding the
primer in for a second
before releasing it each
time.
4. Pull the recoil
starter.
5. With the engine running, move the choke lever to
the left slowly.
Stopping the Engine
To stop the engine, turn the ignition key
counterclockwise to the Off position.
m-6189
m-6108a
m-6109a
m-6192