Philips BDP2500 Service Manual page 11

Software check and upgrade
Preparation to upgrade software
1)Start the CD burning software & create a folder named "UPG",
2)Then copy the Bin file (BDP25XXXX-XXX-XXXXXX.bin) into it,
3)Burn the data onto the blank CD.
A. Procedure for software upgrade
A) Upgrade software via Disc
1) Power on the set and insert the prepared Upgrade
CDR.
2) The set will starts reading disc & response with the
following display TV screen:
Now searching for upgrade software!
Please wait...!
3) Press <OK> button to confirm, then screen will display :
An upgrade software has been found!
Start upgrade with version:WKXXX.X?
Cancel
4) Press Right cursor button to choose "Start", then press <OK>;
5) The software will updagrde and screen will display as below:
Upgrade is ongoing, Please wait...
Please do not unplug or switch off the device.
6) The screen will display as below when upgrading complete:
Upgrade has completed successfully!
Power off after 1s.
5) Restart the set.
B) Update software via USB Flash Drive:
1) Go to www.philips.com/support to check if the latest software
version is available for this player.
2) Download the software onto a USB flash drive.
3) Insert the USB flash drive to the USB jack of the rear panel.
4) In the Home menu, select <Setting>-<Advanced Setup>-<Software
Download>-<USB>.
5) Follow the instructions on the TV screen to confirm update operation.
* Once software update is complete, this player automatically turns to
standby.
6) Disconnect the power cord for a few seconds and connect again to
turn on the player.
Still
Start
Power Off
4-1
B. Read out the software versions to confirm upgrading
1) Power on the set and open the tray door.
2) Press <Home> button on the reomote control.
3) Select <Setting>, then press <OK>.
4) Select <Advanced Setup>, press right cursor to choose
<Version Info.>, then press <OK>, the software version
and other information will display on the TV screen as below:
Mainboard:XXX.XXX
Driver:XXXXXX XXXXXXXX
BDP25XX
http://www.philips.com/support
Caution: The set must not be power off during
upgrading, otherwise the Main board will be
damaged entirely.
DVD Region code change
1).Power on the set and keep no disc.
2).In the Home menu, press <6><6><6><6> button.
3).Input below new region number by the remote control, then it
will change after restart the player.
Remark:
1. There is only 12/05 at present ,if PHILIPS add others regions,
we will provide the method change DVD region.
2. BD disc region code change only by upgrade software.